Matt's Engineering Blog

This week I started by finally attaching a bracket to the bottom of the screw so that the weight of the bearings would not make the screw...

I started this week by attempting to fix a minor issue that had been occurring where the screw had been falling out of the pipe when the...

This week I started by fixing the ramp since I had glued it backward the first time, and then I was running into some issues with the...

This week I started by attaching the bottom of the screw pipe to the bottom of the board, and they lined up well so I had no issues...

This week I began by cutting out two circles that would stop the ball from rolling out of the bottom when they were being put into the...

This week I began by creating a model in CAD of the PVC pipe to motor connector and I was happy with its design. I made holes at the side...

This week I began by printing out the other half of the Archimedes screw which took a long time but I finally tried using a raft to print...

This week I started by designing the board holder for my Plinko machine. After I finished designing that I wanted to finally print out my...