Week of 11/11 - 11/15

I started this week by attempting to fix a minor issue that had been occurring where the screw had been falling out of the pipe when the balls fell on it which would slowly push it out of place. I tried to fix this by making a bracket that I could attach to the bottom corner and unscrew if I needed to, however, this didn't work very well so I have started to design a 3d printed version where it will just attach.

The next thing I did this week was to think about what I wanted to work on for my next practice since I needed a break from my current project after working on it for so long. I want to do something with either a top or trying to keep a wheel/disk spinning for as long as possible. I watched a few videos on ideas for projects, and I created a little prototype that worked pretty well. It spun for a long time without crashing into stuff.