Matt's Engineering Blog

This week, I started by finishing up attaching the brushes to the two prongs that I created. They were a bit tricky to get on, and I had...

This week, I started by testing my spinning device, and every time, it would slide off the slider I put in the way so that it would not...

This week, I started by printing out the spinner design I had created last Friday since the arms in the previous spinner didn't work very...

This week, I started by designing a better cylinder and spinner for my contraption. When the band was on the older cylinders, it would...

This week I started by finishing designing the cylinders and then printed them out on the new printer. I designed them so that one of...

This week I started by redesigning my band machine thing so that I could put bearings on it and also to make it a lot more stable. I also...

This week I started by redesigning the band frame and I included a second frame so that there would be a lot more stability. I had to...

At the start of the week, I was aiming to create a way to spin the motor from far away so that the motor magnet would not interfere with...