Week of 9/30 - 10/4

This week I started by designing the board holder for my Plinko machine. After I finished designing that I wanted to finally print out my Archimedes screw so I used the 4th regular 3d printer as the 2 large ones weren't working. Still, the print came out dirty and a little messed up, so I tried using the Neptune 3 Pro instead, which worked much better.

First print:

Second print with Neptune 3 Pro:

Then I tried printing the other half of the screw with the Neptune three pro but I think there is a dead spot in the lower left corner so on Friday I will try again without using the left corner.